I used to love microtik but these two units I recently purchased have been nothing but trouble.
Detailing the setup procedure to as I seem to have to redo it.
Erase Config – Hold down reset button while powering up. Until LED light flashes quickly.
Connect to 192.168.88.1
IP Addresses set 10.0.0.141 for House.
IP Routers Add Gateway 10.0.0.138
System SNTP set to preferred NTP Server.
System Time Set Timezone to Australia/NSW
Bridge Add New
Bridge Ports Add Ether
Bridge Ports Add Wireless
Lost Access Grrr.
Erase Config – Hold down reset button while powering up. Until LED light flashes quickly.
IP Address 10.0.0.141
Router Identity MikroTik-House
DHCP Server Off
NAT Off
Apply Config and everything disappears!
Oh its changed the IP, but no notice, just all settings go blank.
Interface AddNew Bridge
IP Addresses Add 10.0.0.142 to Bridge
IP Routers Add Gateway 10.0.0.138
FGDHFHF Lost access again?!!??!
Erase Config – Hold down reset button while powering up. Until LED light flashes quickly.
IP Addresses Add 10.0.0.141 to wlan.
https://wiki.mikrotik.com/wiki/Transparently_Bridge_two_Networks
Changed to Bridge and off air fuushfhfing again
Erase Config – Hold down reset button while powering up. Until LED light flashes quickly.
IP Address 10.0.0.141 to wlan0
Erase Config – Hold down reset button while powering up. Until LED light flashes quickly.
Jump into winbox and click remove config, as I don’t want DHCP etc and then 3 seconds later I’m disconnected… Why fuufjfcking bother giving me the option if it will fuufdcking just wipe config and brick it?!?!?!
https://wiki.mikrotik.com/wiki/Transparently_Bridge_two_Networks
Followed Command prompts and it worked… fudkkdkfck
Now the 192.168.88.1 IP one ONE of the ends has disappeared… fuufUFJJCL. I can ping it but no web…